For more information and recommended wallpaper pastes, please see 'Product Care' below.
This wallpaper design is a non-woven, 'paste the wall' paper. Please note that a maximum of 2 samples (measuring 52cm wide x 30cm high) may be ordered of any 1 design. Wallpaper samples are available, so you can try before you buy. Available in three stunning colour combinations, including Blush/White, Silver/White and Stellar Blue/White, this is a wallpaper for all ages, from newborn to teens and beyond. Once all the panels have been hung, trim off any excess paper using a trim guide and a sharp knife.Make a statement with this bold and striking Stars Wallpaper by Hibou Home. If there are any spots of paste on the front of the wallpaper, use a damp cloth or sponge to remove them, but avoid rubbing. Any small bubbles and folds will disappear once the wall mural has dried. Use your hands or a wallpaper brush, starting from the middle and smoothing out towards the edges. Smooth down the panels from the ceiling to floor Note: Avoid harsh folds as this may cause cracks in the print.ĥ. Be careful to match up the pattern with the next panel, and avoid getting wallpaper paste on the front of the mural as this will show when it dries. Take care to press the panels together firmly at the seams – use a seam roller for the best results. Apply the paste approximately one panel width in advance. It’s important to cover the whole area with paste – an unpasted spot will create a blister in the wall mural.
Make sure the markings are faint so they don’t show through the wall mural. Use the markings as a guide to hang the first panel. It is a good idea to draw vertical markings one panel width (50 cm) in from the corner usingĪ spirit level, a measuring tool and a pencil. It is vital that the first panel is hung straight. The panels are numbered at the top in the order they should be hung. If you are using ready-mixed wallpaper paste, use a paste for non-woven wallpaper or one for woven wallpaper with <20% dry content.īefore hanging, make sure no panels are missing and none have any defects or damage. If you do add more, the wallpaper may not fix properly. The paste should be nice and thick, so don’t use more than 4 litres (1 US gallon) of water when mixing. Leave the paste to stand for 5 minutes and stir again. You should also prime the surface if it has bright colours that could show through the wall mural.įill a clean bucket with 4 litres (1 US gallon) of lukewarm water and slowly add the paste powder while stirring briskly. If you hang our premium murals on a dense surface that does not absorb moisture, it may take several days for the paste to dry, as our premium papers are not as breathable as our standard ones. Porous surfaces include skimmed walls, walls with old wallpaper, particle board or similar. If the surface is porous, please apply a primer/mist coat or prepaste before papering. Clean the sur- face and apply ller where necessary.
Remove any old paint or wallpaper that is coming off. Make sure the surface is smooth and clean
0 kommentar(er)
